Expander set spurs Spin S6000 for 1/4 ", 3/8", 1/2 ", 5/8", 3/4 ", 7/8" diameter completed in 5 sec

Turning tools have been developed for use with drills or screwdrivers of at least 1800 rpm and 500 watts or higher in cable drills and 1800 rpm and 18V or higher in cordless screwdrivers. Using the turning tool with less powerful tools can result in smoother performance.

INSTRUCTIONS:
1. Make sure the pipes are always securely fastened. You can use it for your other hand. Keep a safe distance between your hand and the edge of the pipe.
2. Fix the expansion set according to the pipe diameter in the drill or screwdriver coupling and make sure it is not loose.
3. Make sure the HAMMER MODE is off. Turn on the unit, push the power lever, and keep the drill / screwdriver at MAXIMUM SPEED.
4. Hold the pipe ALWAYS aligned with the drill / driver and DRY the widening set inwards, leaving a CONSTANT PRESSURE until the stopper overcomes the pipe.
5. Hold the pipe in line with the drill / driver and at the same time run the drill / screwdriver at MAXIMUM SPEED. Then pull the expander set from inside the tube. Remember, the whole expansion process should take no longer than 5 to 7 seconds.
6. Immediately after the expansion process, the tube temperature is very high. Do not overdo. Wait for the tube to cool down before overflowing.
7. Assemble the accessories as usual.

SAFETY INSTRUCTIONS:
1. The expansion sets work with a HIGH TEMPERATURE technology; the temperature is due to the friction between the metal tube and the tool. For safety reasons, always assume that the device is hot.
2. Wait for the metal tube to cool before touching the surface of the tube or tool by hand.
3. Always use protective gloves when working with the widening set (SFI LEVEL 10 protective gloves). Direct skin contact with the tube or tool can cause serious injury and burns.
4. Note that the broom tool is always well fastened in the used tool (cord or cordless drill).
5. Always use safety goggles when working with the widening set. ANSI Z87.1 Eye Protection (CAN / CSA Z94.3). Occasionally, spills may form and get into your eyes during the dilation process, causing serious injury, burns, or even loss of sight.
6. Do not wear loose clothing or jewelery, and do not cling to the running tool with long, open hair, as it may entangle itself, which could cause serious injury.

You k? Ol; You may also like to watch video .